Gaggenau CM200610 - Manual (Page 31)

31
Trouble shooting
Malfunction Cause Remedial action
ADD BEANS is
displayed despite
a full bean container
Grinder has still not been
filled automatically.
Press the n button.
a full bean container. The beans are too big or too
oily - they do not slide into
the grinding unit.
Use less oily or smaller
beans. To remove big beans
use a vacuum cleaner.
No hot water or
steam discharge.
Nozzle is blocked. Thoroughly clean nozzle.
Froth insufficient or
too runny.
Sleeve a on nozzle 12 not in
correct position.
Push down sleeve a
on nozzle 12.
Unsuitable milk. Use cold semiĆskimmed milk.
Coffee is running
a drop at aĂtime.
Degree of grinding too fine. Select a coarser degree of
grinding.
The beans are too oily. Use less oily beans.
Preground coffee too fine. Use a coarser ground coffee.
To rinse the appliance,
follow the instructions Using
ground coffee" on page 14,
but do not add coffee
powder in the duct.
Coffee has no
crema"
Unsuitable type of coffee. Change the type of coffee.
crema"
(layerĂof froth).
Beans no longer fresh. Use fresh beans.
(layerĂof froth).
Degree of grinding not
appropriate for coffee beans.
Optimize degree of grinding.
Grinding unit is not
grinding coffee
beans.
Beans are not falling into
the grinding unit (too oily).
Gently tap the bean
container.
Descaling program
does not start.
Current programming set to:
FILTER YES/NEW or
CHANGE FILTER
display.
Set programming to
FILTER NO/OLD ć
Before descaling
the appliance, always remove
the filter.
System too hot. Draw off some of the hot
water.