Greenheck Fan USGF - Manual (Page 6)


Options and Accessories
PERMATECTOR®
HI-PRO
POLYESTER
BAKED
ENAMEL
HI-PRO
POLYESTER
Self Draining Grease System:
Drain grease and rain water
back through the ductwork
into the specially designed
Greenheck hood. The hood
then channels grease and rain
water into the restaurant’s floor
grease trap.
Coatings: Wide variety of coatings and colors are
available for decorative to acidic applications.
Permatector™ is our standard coating.
Typically used for applications that
require corrosion resistance in indoor
and outdoor environments.
Hi-Pro Polyester is resistant to salt
water, chemical fumes and moisture in
more corrosive atmospheres. Typically
used for applications that require
superior chemical resistance, excellent
abrasion and outdoor UV protection. This
coating exceeds protective qualities of
Air Dried Heresite and Air Dry Phenolic.
Baked Enamel Decorative Coatings
are heat cured enamels applied either
as wet paints or electrostatic powders.
Customers can choose from 16 standard
decorative colors or color match any
color.
Windband Extension: Tube that raises fans
discharge an additional 36 in. for special code
requirements.
Curb Seal: Rubber seal between fan and curb to
assure proper sealing when attached to a curb.
Roof Curbs: Wide variety of roof curbs are
available for mounting the fan to the roof, including:
vented, flanged, pitched.
Vented Curb Extension:
Mounts between roof
curb and roof mounted
fans to meet NFPA
requirements of 40 in.
minimum discharge
above the roof when
mounted on a minimum
8 in. high roof curb.
Severe Duty Curb: Model SD is specifically
designed for the optional hurricane use. It is
attached directly to the building structure with
extremely high structural design load requirements.
Maximum design load is 130 psf.
Drain Connection:
Allows for single point
drainage of grease, water
or other residues.
Grease Trap: Aluminum
trap designed to collect
grease residue to avoid
drainage onto roof
surface.
Grease Trap with
Absorbent Material:
Same as above with an
absorbent material to
collect grease residue
and repel water for easy
periodic disposal.
Tie Down Points: Four
brackets located on the
windband for securing
the fan in heavy wind
applications.
Velocity Accelerator: Increases fan outlet/
discharge velocity. Up to 3,000 feet per minute.