GE DEH-210 - Manual (Page 154)

148
•
Features of Tabular Data Screen Wizards PMCS Interface Toolkit
The Metering tab displays the following metered values from the B30, C60, D60,
F30, F35, F60, G60, L60, L90, M60 and T60 devices: Actual Values for Voltage,
Current, Power, Power Factor, and Frequency. These values are detailed below.
Current
RMS Current for each phase, ground, and neutral
Phasor magnitude and angle for each phase, ground and neutral
Voltage
RMS voltage for each phase-to-phase, phase-to-neutral, and auxiliary voltage value.
Phasor magnitude and angle for phase-to-phase, phase-to-neutral and auxiliary
voltage value.
Phase-to-neutral voltages are displayed as "N/A" if derived from a source wired in a
delta configuration.
Power
Shows Real (Watts), Reactive (VAR), and Apparent (VA) power values per phase
and 3-phase.
By default, all power values are displayed in terms of kW, kVAR, and kVA. These
values will scale as appropriate to MW, MVAR, and MVA.
Power values derived from a source wired in a delta configuration are displayed as
"N/A".
Power Factor
Shows the signed power factor value in percent.
Power Factor values derived from a source wired in a delta configuration are
displayed as "N/A".
Frequency
Frequency is shown in units of hertz.
Frequency is only displayed if the Frequency Tracking Reference setpoint is set to a
non-zero value.