GE DECT6.0 28128 - Manual (Page 14)

14
. Install 4 AAA-size alkaline batteries (not included) for back up power in the event
of a power failure.
• Press the tab to open the battery compartment door located on the back of
the phone.
• Insert the batteries as shown on the diagram inside the battery compartment.
• Insert the tabs into place and snap the battery compartment door closed.
NoTE: If LOW BATTERY appears in the base display, you need to
replace the back up batteries. It is important that you replace them
as soon as possible to maintain unit operation when electrical
power is off. As a precaution, you may want to write down any
stored information you do not want erased.
IMPorTANT: If you are not going to use the telephone for more
than 30 days, remove the batteries because they can leak and
damage the unit.
. Plug one end of the telephone line cord into the TEL LINE jack on the bottom of the
base and the other end into a modular jack.
. Plug the AC power converter into the electrical outlet and the DC connector into
the jack on the bottom of the base.
4. Place the handset in the base cradle. The CHARGE IN USE indicator turns on,
verifying the battery is charging.
b
ase
s
tatIon
1. Choose an area near an electrical outlet and a telephone wall jack (RJ11C), and
place your cordless telephone on a level surface, such as a desktop or tabletop,
or you may mount it on the wall.