GE DECT6.0 28128 - Manual (Page 60)

60
Unit beeps
• Clean charging contacts on cordless handset.
• See solutions for “No dial tone”.
• Replace the battery.
Memory Dialing doesn’t work
• Did you program the memory location keys correctly?
• Did you follow proper dialing sequence?
Unit locks up and there is no communication between the base and cordless handset
• Unplug the AC power adaptor from the wall outlet and the back of the base.
Remove the back up batteries from the base. Remove the handset battery.
Wait for 0 seconds and insert the backup batteries into the base, then plug
the power adaptor back into the base and wall outlet. Reconnect the handset
battery and charge for 16 hours.
Handset displays SEARCHING or OUT OF RANGE and cannot link up with the base
when the TALK button is pressed.
• Handset may be out of range of the base. Move closer to the base.
• Make sure the power adaptor is properly installed.
• Disconnect the handset battery and plug it in again. Place the handset on the
cradle for at least  to  minutes.
• Disconnect the power adaptor and remove the back up batteries from the
base. Wait for  seconds and insert the backup batteries into the base, then
plug the power adaptor back into the base. Replace the handset on the cradle
for at least  to  minutes.
Handset displays HANDSET NEEDS REGISTRATION
• Follow the programming in the telephone procedures to re-register the
handset to the base.
• Press the Select (SKL) button to begin handset registration. Follow instructions
on Handset screen.
Caller ID Solutions
No Display
• Charge the battery (for 16 hours). Or replace the battery.