GM None Pontiac Aztek - Manual (Page 124)

Replacing the Floor Track Assembly
Before beginning this procedure make sure that nothing
is in the rear of the vehicle.
1. Slide the floor track assembly in while aligning the
front forks, located on the bottom front of the track
assembly, so that the forks slide under the two
front floor retainers.
2. Insert the slide locks under the two rear floor
retainers by pushing the button down and pressing
them outward.
You may have to apply downward pressure to the
floor track assembly to engage the slide locks under
the floor retainers.
Double check to ensure that the slide locks are
engaged under the retainers and locked into place.
3. Feed the tethered ring upward through the lower
sidewall loop on each side of the vehicle.
Make sure that the tethered ring is placed on the
outer edge of the tailgate, on each side of the
vehicle, for later attachment to the tray.
4. Push and pull on the floor track assembly to make
sure it is locked into place.
2-46