Grundig GDP 3564 - Manual (Page 13)

ENGLISH
13
Connecting with a cinch cable (progressive scan)
Caution:
This connection results in the transmission of video signals in a
high frequency range. Before you first switch on the device,
please check whether your television, flat screen or projector is
suitable for this use.
GRUNDIG accepts no liability for damage resulting from failure
to observe this.
Notes:
If you connect the DVD player using the » Y «, » Pb/Cb « and
» Pr/Cr « sockets you have to carry out the setting described in
the “Selecting the video output socket” section on page 18.
Then you can use the »
x « button to select whether the video
signal is provided in progressive mode or interlace mode.
Depending on the model of television, flat screen or projector,
you have to activate the relevant input sockets on the device.
1 Plug standard cinch cables into the » Y «, » Pb/Cb « and
» Pr/Cr « sockets on the DVD player and into the corresponding
socket (VIDEO IN or COMPONENT Y P
B
/C
B
P
R
/C
R
) on the
television, flat screen or projector.
2 Plug standard cinch cables into the » R AUDIO OUT L « sockets
of the DVD player and into the appropriate sockets (AUDIO IN)
on the television, flat screen or projector.
CONNECTION AND PREPARATION
_
EURO AV S VIDEO OUT
DIGITAL AUDIO OUT AUDIO OUT
Pr/Cr Y Pb/Cb
R L HDMI OUT
VIDEO OUT
EURO AV S VIDEO OUT
DIGITAL AUDIO OUT AUDIO OUT
Pr/Cr Y Pb/Cb
R L HDMI OUT
VIDEO OUT
100-240 V~
50/60 Hz 15 W
EURO AV TV S VIDEO OUT
DIGITAL AUDIO OUT AUDIO OUT
Pr/Cr Y Pb/Cb
R L HDMI OUT
VIDEO OUT
P B C B P R C R Y D
R L
AUDIO
INPUT
GDP 3564,GB 26.10.2005 12:49 Uhr Seite 13