GE 27958 - Manual (Page 25)

25
NOTE: If you make a mistake, press the DELETE button on the base or chan/
delete on the handset to backspace and erase the wrong character(s) or number(s).
6. Use the touch-tone pad to enter the area code followed by the telephone
number (up to 24 digits, including pauses) and press the memory button
again to save your selection. The unit beeps to confirm.
7. To enter another name and number in a different memory location,
return to step 1 and repeat the process.
S
TORING A
R
EDIAL
N
UMBER
1. Make sure the phone is OFF (not in TALK mode).
2. Press the MEMORY/CONFERENCE (base) or mem/conference (cordless
handset) button.
3. Press any number key (0-9) to store the phone number in that memory location.
4. Press MEMORY/CONFERENCE and ENTER NAME shows in the display.
5. Use the base or cordless handset touch-tone pad to enter the name,
then press MEMORY/CONFERENCE . ENTER TEL NUMBR shows in the
display.
6. Press REDIAL to display the redial number and name.
7. Press MEMORY/CONFERENCE again to confirm.
NOTE : If the number you want to redial has more than 24 digits, the
telephone number cannot be stored in memory.
I
NSERTING A
P
AUSE IN THE
D
IALING
S
EQUENCE
Press the #PAUSE button on the touch-tone pad twice to insert a delay in
the dialing sequence of a stored telephone number when a pause is
needed to wait for a dial tone (for example, after you dial 9 for an outside
line, or wait for a computer access tone.) Each pause counts as 1 digit in
the dialing sequence.
R
EVIEWING
, C
HANGING OR
D
ELETING
S
TORED
N
AMES
/N
UMBERS
To Review: Press MEMORY/CONFERENCE (base) or mem/conference
(cordless handset) button, then press the MESSAGES/CID (
or ) button
(base) or the cid/vol ( or ) button (cordless handset) to scroll through
the stored numbers. Or press the memory location number.