GE 27958 User Manual
Page 37
37
Skip message
3
Turn off/on answering system
4
Review voice menu options
7
The base LCD shows
REMOTE ACCESS ANSWERING CALL.
TIP:
You can bypass the outgoing announcement by pressing any numbered
key on the touch-tone pad while the announcement is playing. Then, you can
enter your security code to access the answering system.
C
HANGING
THE
S
ECURITY
C
ODE
The default security code for accessing the answering system from
another location is 1 2 3.
The security code is set through the programming menu. Refer to
Telephone Set Up for more information.
C
HANGING
THE
B
ATTERY
Make sure the telephone is OFF (not in TALK mode)
before you replace battery.
1. Remove the battery compartment cover.
2. Disconnect the battery plug from the jack inside the
battery compartment and remove the battery pack
from the handset.
3. Insert the new battery pack and reconnect the battery
plug to the jack inside the compartment.
4. Put the battery compartment cover back on.
5. Place handset in charge cradle to charge. If you don’t
charge the handset battery properly (for 12 hours)
when you first set up the phone and/or when you
install a new battery pack, the battery’s long-term
performance will be compromised.
NOTE:
If the battery is not properly installed in the handset, or if the battery
pack is not properly connected to the jack inside the battery compartment,
“NO BATTERY” flashes in the display.