GE 27958 - Manual (Page 40)

40
REPT Repeat call message. Indicates that a new call
from the same number was received more
than once.
NO DATA No Caller ID information was received.
WAITING HANDSET Prompt telling you to enter registration mode
REGISTRATION of handset
NO BATTERY No battery is installed in the handset or the
battery is not properly connected to the battery
jack inside the battery compartment.
H
ANDSET
S
OUND
S
IGNALS
Signal Meaning
A long warbling tone (with ringer on) Signals an incoming call
Three short beeps Page signal
One short beep (every 7 seconds) Low battery warning
T
ROUBLESHOOTING
G
UIDE
T
ELEPHONE
S
OLUTIONS
No dial tone
• Check and repeat installation steps:
Ensure the base power cord is connected to a working outlet .
Ensure the telephone line cord is connected to the base and the wall jack .
• Connect another phone to the same jack; if there is still no dial tone, the
problem might be your wiring or local service.
• The cordless handset may be out of range of the base. Move closer to
the base.
• Ensure the battery is properly charged (12 hours).
• Ensure the battery pack installed correctly.