Moxa Technologies CP-118U - Manual (Page 64)

CP-118U User’s Manual Software Installation
3-52
8. Press Enter to return to the main screen.
Smartio Family Installation Utility (Ver 1.6)
Smartio Family Basic Configuration
Board No. Board Type I/O Address Interrupt Bus/Dev No.
1 CP-118U AC00 5 2/13
2 None ------------- ------------- -------------
3 None ------------- ------------- -------------
4 None ------------- ------------- -------------
PgDn: getty Setting
Enter: Confirm Input Value
Esc: Exit
Tab: Change Item
9. Press Esc to save the configuration and exit.
Save configuration changes? (Y/N)
10. The driver files will be copied to the SCO system. Press any key to continue.
--------------------------[Message] --------------------------
Copying driver files and configuring system. Please wait….
Press any key to continue! _
11. Press Y to rebuild the system.
--------------------------[Message] --------------------------
Do you want to rebuild the system? (y/n)_
12. The window shown below will open next.
--------------------------[Message] --------------------------
Do you want to rebuild the system? (y/n)_
Rebuilding kernel. Please wait….
13. After the system is rebuilt, the system will return to shell command. At this point, you can
begin to use your MOXA Smartio Multiport Serial Board.
--------------------------[Message] --------------------------
Do you want to rebuild the system? (y/n)_
Rebuilding kernel. Please wait….
Rebuilding kernel completed.
Please remember to manually reboot your system later.
Press any key to continue. _