Motorola MVME166IG/D2 User Manual
Motorola Notebooks
Advertising
Table of contents
Document Outline
- BOARD LEVEL HARDWARE DESCRIPTION
- Introduction
- Block Diagram
- Functional Description
- Memory Maps
- HARDWARE PREPARATION AND INSTALLATION
- Introduction
- Unpacking Instructions
- Hardware Preparation
- Installation Instructions
- DEBUGGER GENERAL INFORMATION
- Overview of M68000 Firmware
- Description of 166Bug
- 166Bug Implementation
- Installation and Startup
- BOOTBUG
- Autoboot
- ROMboot
- Network Boot
- Restarting the System
- Memory Requirements
- Terminal Input/Output Control
- Disk I/O Support
- Network I/O Support
- Multiprocessor Support
- Diagnostic Facilities
- USING THE 166Bug DEBUGGER
- Entering Debugger Command Lines
- Entering and Debugging Programs
- Calling System Utilities from User Programs
- Preserving the Debugger Operating Environment
- Floating Point Support
- The 166Bug Debugger Command Set
- CONFIGURE AND ENVIRONMENT COMMANDS
- Configure Board Information Block
- Set Environment to Bug/Operating System
- DISK/TAPE CONTROLLER DATA
- Disk/Tape Controller Modules Supported
- Disk/Tape Controller Default Configurations
- IOT Command Parameters for Supported Floppy Types
- NETWORK CONTROLLER DATA
- Network Controller Modules Supported