Motorola MVME166IG/D2 - Manual (Page 118)

Index
IN-2 MVME166 Sngle Board Computer Installation Guide
I
N
D
E
X
CISC Single Board Computer(s) (SBC)
B-1
Clear To Send (CTS) 3-6
CLUN (controller LUN) B-2, C-1
command identifier 4-1
command line 4-1
configuration, default disk/tape control-
ler B-2
configuration, hardware 3-4
Configure (CNFG) and Environment
(ENV) commands A-1
Configure Board Information Block (CN-
FG) A-1
connector J9 4-8
connectors 1-17
console port 4-8
control bit 1-7
controller B-1
controller LUN (CLUN) B-2, C-1
count 4-2
creating a new vector table 4-13
CTS (Clear To Send) 3-6
D
data bus structure 1-10
debug monitor (see 166Bug and
MVME167Bug) 2-2
debug port 4-8
debugger address parameter formats 4-5
debugger commands 4-20
debugger general information 3-1
debugger prompt 4-1
decimal number 1-6
default 166Bug controller and device pa-
rameters 3-18
default baud rate 3-6
delimiter 4-2
description of 166Bug 3-1
device LUN (DLUN) B-2, C-1
device probe function 3-16
diagnostic facilities 3-23
direct access device B-2, B-4
disk I/O error codes 3-19
disk I/O support 3-15
disk I/O via 166Bug commands 3-16
disk I/O via 166Bug system calls 3-17
disk/tape controller data B-1
disk/tape controller default configura-
tions B-2
disk/tape controller modules supported
B-1
DLUN (device LUN) B-2, C-1
double precision real 4-18
download 4-9
download EPROM 1-19
DRAM (dynamic RAM) 1-12
DRAM base address 2-8
dynamic RAM (DRAM) 1-12
E
EIA-232-D 1-14
EIA-232-D port(s) 3-6, 4-10
entering and debugging programs 4-9
entering debugger command lines 4-1
ENV command parameters A-3
Environment (ENV) and Configure (CN-
FG) commands A-1
EPROM (see also download EPROM) 2-6
ESDI Winchester hard drive B-3
Ethernet (see 82596CA and LAN) C-1
Ethernet interface 1-15
Ethernet station address 1-16
exception vectors used by 166Bug 4-11
Execute User Program (EXEC) 3-8
exponent field 4-17
expression 4-2
expression as a parameter 4-3
extended addressing 2-8
extended precision real 4-18
F
false 1-7
features 1-5
Flash memory 1-10