Motorola MVME166IG/D2 - Manual (Page 100)

Configure and Environment Commands
A-8 MVME166 Single Board Computer Installation Guide
A
Slave Starting Address #2 FFE00000 Base address of the local
resource that is accessible by the
VMEbus. Default is the base
address of static RAM,
$FFE00000.
Slave Ending Address #2 FFE1FFFF Ending address of the local
resource that is accessible by the
VMEbus. Default is the end of
static RAM, $FFE1FFFF.
Slave Address Translation Address #2 00000000 Works the same as Slave
Address Translation Address #1.
Default is 0.
Slave Address Translation Select #2 00000000 Works the same as Slave
Address Translation Select #1.
Default is 0.
Slave Control #2 01EF Defines the access restriction for
the address space defined with
this slave address decoder.
Default is $01EF.
Master Enable #1 [Y/N] Y Yes, Setup and enable the Master
Address Decoder #1.
Master Starting Address #1 02000000 Base address of the VMEbus
resource that is accessible from
the local bus. Default is the end
of calculated local memory,
unless memory is less than
16MB, then this register will
always be set to 01000000.
Master Ending Address #1 EFFFFFFF Ending address of the VMEbus
resource that is accessible from
the local bus. Default is the end
of calculated memory.
Master Control #1 0D Defines the access characteristics
for the address space defined
with this master address
decoder. Default is $0D.
Master Enable #2 [Y/N] N Do not setup and enable the
Master Address Decoder #2.
Master Starting Address #2 00000000 Base address of the VMEbus
resource that is accessible from
the local bus. Default is
$00000000.
Table A-1. ENV Command Parameters (Continued)
ENV Parameter and Options Default Meaning of Default