Motorola MVME166IG/D2 - Manual (Page 99)

Set Environment to Bug/Operating System
MVME166IG/D2 A-7
A
Size of Local Memory Board #0
Size of Local Memory Board #1 02000000
00000000 You are prompted twice, once
for each possible MVME166
memory board. Default is the
calculated size of the memory
board.
Slave address decoders setup. The slave address decoders are use to allow another VMEbus master
to access a local resource of the MVME166. There are two slave address decoders set. They are set
up as follows.
Slave Enable #1 [Y/N] Y Yes, Setup and enable the Slave
Address Decoder #1.
Slave Starting Address #1 00000000 Base address of the local
resource that is accessible by the
VMEbus. Default is the base of
local memory, $0.
Slave Ending Address #1 01FFFFFF Ending address of the local
resource that is accessible by the
VMEbus. Default is the end of
calculated memory.
Slave Address Translation Address #1 00000000 This register will allow the
VMEbus address and the local
address to be different. The
value in this register is the base
address of local resource that is
associated with the starting and
ending address selection from
the previous questions. Default
is 0.
Slave Address Translation Select #1 00000000 This register defines which bits
of the address are significant. A
logical one "1" indicates
significant address bits, logical
zero "0" is non-significant.
Default is 0.
Slave Control #1 03FF Defines the access restriction for
the address space defined with
this slave address decoder.
Default is $03FF.
Slave Enable #2 [Y/N] Y Yes, Setup and enable the Slave
Address Decoder #2.
Table A-1. ENV Command Parameters (Continued)
ENV Parameter and Options Default Meaning of Default