Miele DA 337 I - Manual (Page 29)

2. Reducing collar
Air extraction
The appliance is designed for vent
ducting 6” (150 mm) diameter.
If a 5” (125 mm) diameter is required:
Place the reducing collar supplied
on the vent socket and turn it to se-
cure it in position (see ”Connection
for air extraction”).
Recirculation mode
Place the reducing collar for a 5”
(125 mm) diameter on the vent
socket as described previously.
3. Runners
Now fit the two runners into the cabinet.
If the appliance is being installed in a
27
9
/
16
” (70 cm) wide cabinet the run-
ners are fitted with the spacer blocks.
Draw a vertical line 7
7
/
8
” (20 cm)
long 3” (75 mm) in from the front
edge of the cabinet.
Installation
29