Multiquip MQPower Whisperwatt Series DCA-300SSK - Manual (Page 25)

DCA-300SSK SERIES — PARTS AND OPERATION MANUAL (STD)— REV. #4 (03/27/06) — PAGE 25
120 VAC GFCI Receptacles
There are two 120 VAC, 20 amp GFCI (Duplex Nema 5-20R)
recepacles provided on the output terminal panel. These
receptacles can be accessed in any
voltage change-over
board position. Each receptacle is protected by a 20 amp
circuit breaker. These breakers are located directly above
the GFCI receptacles. Remember the load output (current)
of both GFCI receptacles is dependent on the load
requirements of the UVWO terminals.
Pressing the reset button resets the GFCI receptacle after
being tripped. Pressing the " Test Button" (See Figure 9) in
the center of the receptacle will check the GFCI function.
Both receptacles should be tested at least once a month.
Figure 9. G.F.C.I. Receptacle
Each auxiliary receptacle is protected by a 50 amp circuit
breaker. These breakers are located directly above the GFCI
receptacles. Remember the load output (current) on all three
receptacles is dependent on the load requirements of the
UVWO terminals.
Turn the voltage regulator control knob (Figure 11) on the
control panel to obtain the desired voltage. Turning the knob
clockwise will
increase the voltage, turning the knob counter-
clockwise will decrease the voltage.
Figure 10. 240/139 VAC Twist-Lock
Auxiliary Receptacles
DCA-300SSK SERIES — OUTPUT TERMINAL PANEL FAMILIARIZATION
Twist Lock Dual Voltage 240/139 VAC Receptacles
There are three 240/139 VAC, 50 amp auxiliary twist-lock
(CS-6369) receptacles (Figure 10) provided on the output
terminal panel. These receptacles can be accessed in any
voltage change-over board position.
Figure 11. Voltage Regulator Control Knob