Multiquip MQPower Whisperwatt Series DCA-300SSK User Manual
Page 39
DCA-300SSK SERIES — PARTS AND OPERATION MANUAL (STD)— REV. #4 (03/27/06) — PAGE 39
DCA-300SSK SERIES — GENERATOR START-UP PROCEDURE (MANUAL)
15. The engine oil pressure gauge (Figure 52) will indicate
the oil pressure (kg/ cm
2
)
of the engine. Under normal
operating conditions the oil pressure is approximately
Figure 52. Oil Pressure Gauge
Figure 54. Engine Tachometer Gauge
17. The
tachometer gauge (Figure 54) will indicate the
speed of the engine when the generator is operating.
Under normal operating conditions this speed is
approximately 1800 RPM’s.
16. The
coolant temperature gauge (Figure 53) will indicate
the coolant temperature. Under normal operating
conditions the coolant temperature should be between
165 and 215 degrees Fahrenheit (
Green Zone).
Figure 53. Coolant Temperature Gauge
WATER
TEMP
0
4
8
kg/cm2
ENGINE OIL PRESSURE
Figure 55. Main, Aux. and GFCI
Circuit Breakers (ON)
18. Place the
main, GFCI, and aux. circuit breakers in the
“ON” position (Figure 55).
19. Observe the generator's ammeter (Figure 56) and verify
it reads the anticipated amount of current with respect
to the load. The ammeter will only display a current
reading if a load is in use.
20. The generator will run until manually stopped or an
abnormal condition occurs.
Figure 56. Ammeter (Load)