Multi-Tech Systems MTASR3-200 User Manual
Page 63
Appendices
MTASR3-200
63
Command:
L
n
Monitor Speaker Volume
Values:
n = 0, 1, 2, or 3
Default:
2
Description:
L0
Select low volume.
L1
Select low volume.
L2
Select medium volume.
L3
Select high volume.
Command:
M
n
Monitor Speaker Mode
Values:
n = 0, 1, 2, or 3
Default:
1
Description:
M0
Speaker always off.
M1
Speaker on until carrier signal detected.
M2
Speaker always on when modem is off-hook.
M3
Speaker on until carrier is detected, except while dialing.
Command:
N
n
Modulation Handshake
Values:
n = 0 or 1
Default:
1
Description:
N0
Modem performs handshake only at communication standard specified by S37 and the
B
command.
N1
Modem begins handshake at communication standard specified by S37 and the
B command.
During handshake, fallback to a lower speed can occur.
Command:
O
Return Online to Data Mode
Values:
0, 1, 3
Default:
None
Description:
O0
Exit online command mode and return to data mode.
O1
Issue a retrain and return to online data mode.
O3
Issue a rate renegotiation and return to data mode.
Command:
Q
n
Result Codes Enable/Disable
Values:
n = 0 or 1
Default:
0
Description:
Q0
Enable result codes.
Q1
Disable result codes.
Command:
S
r=n
Set Register Value
Values:
r = S-register number; n varies
Default:
None
Description:
Set value of register S
r to value of n, where n is entered in decimal format.
Command:
S
r?
Read Register Value
Values:
r = S-register number
Default:
None
Description:
Read value of register
Sr and display value in 3-digit decimal form.
Command:
V
n
Result Code Format
Values:
n = 0 or 1
Default:
1
Description:
V0
Displays result codes as digits (terse response).
V1
Displays result codes as words (verbose response).