Multi-Tech Systems MTASR3-200 User Manual
Page 66
RASFinder User Guide
MTASR3-200
66
Command:
\G
n
Modem Port Flow Control
Values:
n = 0
Default:
0
Description:
\G0
Returns an
OK for backward compatibility with some software.
\G1
Not supported—responds ERROR.
Command:
\J
n
Data Buffer Control
Values:
n = 0
Default:
0
Description:
\J0
Enable data buffer—serial port speed is independent of connect speed.
\J1
Not supported—responds ERROR.
Command:
\K
n
Set Break Control
Values:
n = 5
Default:
5
Description:
\K5
Modem sends break signal received from the DTE to the remote modem.
Command:
\N
n
Error Correction Mode Selection
Values:
n = 0–5, or 7
Default:
3
Description:
\N0
Non-error correction mode with data buffering (same as
&Q6).
\N1
Direct mode.
\N2
MNP reliable mode.
\N3
V.42/MNP auto-reliable mode.
\N4
V.42 reliable mode.
\N5
V.42, MNP, or non-error correction (same as
\N3).
\N7
V.42, MNP, or non-error correction (same as
\N3).
Command:
\Q
n
Local Flow Control Selection
Values:
n = 0, 1, or 3
Default:
3
Description:
\Q0
Disable flow control (same as
&K0).
\Q1
XON/XOFF software flow control (same as
&K4).
\Q2
CTS-only flow control. Not supported—responds ERROR.
\Q3
RTS/CTS hardware flow control (same as
&K3).
Command:
\T
n
Inactivity Timer
Values:
n = 0–255
Default:
n/a
Description:
\Tn
Inactivity timer setting contingent on either \T value or S-Register S30 value (e.g.,
AT\T45&W0<cr> configures in parallel ATS30=45&W0<cr>), and vice versa.
Command:
\V
n
Protocol Result Code
Values:
n = 0 or 1
Default:
1
Description:
\V0
Disable protocol result code appended to DCE speed.
\V1
Enable protocol result code appended to DCE speed.
Command:
\X
n
XON/XOFF Pass-Through
Values:
n = 0 or 1
Defaults:
0
Description:
\X0
Respond to and discard XON/XOFF characters.
\X1
Not supported—responds ERROR.
Command:
-C
n
Data Calling Tone
Values:
n = 0 or 1
Defaults:
0
Description:
-C0
Disable V.25 data calling tone.
-C1
Enable V.25 data calling tone.