Multiquip Mayco Structural Concrete Pump ST-45HRM CE - Manual (Page 29)

MAYCO ST-45HRM CE PUMP — OPERATION & PARTS MANUAL — REV. #0 (02/23/04) — PAGE 29
ST-45HRM CE CONCRETE PUMP— INSPECTION
CAUTION CAUTION CAUTION CAUTION CAUTION
NEVER operate the pump
in a confined area or
enclosed area structure
that does not provide
ample
free flow of air .
ALWAYS wear approved eye and hearing
protection before operating the pump .
NEVER place hands or feet inside the hopper . ALWAYS shut-
down the engine before performing any kind of maintenance on
the pump.
NEVER operate the pumps's engine with the
engine hood or V-belt cover removed. The
possibility exists of
hands , long hair , and
clothing becoming entangled with the V-belt,
causing injury and bodily harm.
Before Starting
1. Read safety instructions at the begin-
ning of manual.
2. Clean the entire pump , removing dirt and dust, particularly
the engine cooling air inlet, and air filter.
3. Check the air filter for dirt and dust. If air filter is dirty, replace
air filter with a new one as required.
4. Check fastening nuts and bolts for tightness.
FUEL CHECK
5. Read the fuel sight tube (Figure 10) on top of the fuel tank
to determine if the pump's engine fuel is low .
Reference Figures 7 through 9 for
the location of any control or
component referenced in this section.
CAUTION:
Handle fuel safely. Diesel fuel is highly
flammable and can be dangerous if
mishandled. DO NOT smoke while refueling.
DO NOT attempt to refuel mixer if the engine is
hot or running. ALWAYS
allow engine to cool
before refueling.
Figure 11. Adding Diesel Fuel
NOTE
Figure 10. Fuel Sight Tube
6. If fuel is low, remove fuel filler cap and fill with #2 diesel
fuel (Figure 11).