Muratec MFX-2500 - Manual (Page 39)

Beyond the Basics
5 The LCD of copy standby mode appears, which
means the machine is ready to register the
steps into the Macro key.
Note: It keeps beeping and blinking the
COPY or FAX key during the job regis-
tration in order to make notice of the
registration mode.
6 Press the keys exactly as you operate the job you want to program into the
Macro key.
Note: If you want to program the fax function, first press FAX . Or, if you
want to program the copier function, first press COPY .
Note: You can program up to 60 steps. When it comes over 60 steps, your fax
machine asks if you register the operations you have entered. If you
want to register them, press [Yes]. If not, press [No].
Note: If you want to cancel the operations you have set, press RESET and
then go back to step 1.
7 If you programmed Start or [Enter] into the operation, proceed to step 8.
Otherwise, press
MACRO PROGRAM and skip to step 9.
8 If you want to start immediately after press-
ing the Macro key when you use it, press
[Yes]. If not, press [No].
Note: If you want to confirm the settings or
operations in the Macro key before
the machine do it, press [No] here.
9 The machine now asks you to name this job.
Enter the name of this job.
A job’s name may be up to 130 characters in
length.
If you do not want to enter or change this job’s
name, skip to step 10.
10 Press [Enter] to save the setting.
The machine will return to standby mode.
To program or modify another job, repeat steps 1–10.
Erasing a Macro key
1 Press MACRO PROGRAM , NEXT .
2 Select the Macro key ( M 1 – M 6) you want to
erase.
3 Press [Erase]. The LCD shows:
Note: If you want to quit without erasing
the Macro key you’ve selected, press
[Cancel]. The fax will return to step
2.
4 Press [Erase] again to erase the job.
To erase another Macro key, repeat steps 2–4. Or press RESET to return to standby
mode.
Printing a list of your Macro keys
Your fax machine can print a list of the commands you’ve stored in your Macro keys.
The list includes:
(1) each key’s Macro key number
(2) the name of the job stored in the Macro key
To print a list of Macro keys, press MACRO PROGRAM , NEXT , [List].
Setting the speed for Macros
You can adjust the speed of one step in the Macro key.
1 Press MACRO PROGRAM , NEXT , [Setting].
2 Select desired speed for Macros using the cur-
sor key.
3 Press [Enter] to save the setting.
A4
A4
2.17