Muratec MFX-2500 - Manual (Page 87)

Trouble Shooting
What you see on the LCD What it means/What to do
Not store in Secure box You tried to store a document for polling in an
F-Code box which is set to be a security box.
Select an F-Code box which is set to be a bulletin
box, then try again.
PIN is not stored You selected “Mode1” in the PIN mask feature
and tried to call an autodialer number in which
no PIN has been entered, or to call using
numeric keypad without
PIN . Enter a PIN , then
try again.
Please call service The printer unit of your fax machine has become
inoperable. Call your authorized Muratec dealer
or Muratec Customer Support.
Please supply paper The paper cassette is out of paper. Add paper to
the cassette.
Please wait Your fax machine’s printer is either warming up
or busy. Please wait until the fax is finished
printing and then re-try your command or opera-
tion.
Printing The command you’re trying to enter requires the
use of the printer, which is already in use. Wait
for the fax to finish printing, then try again.
Scanner in use The command you’re trying to enter requires the
use of the scanner, which is already in use. Wait
for the fax to complete the scan, then retry the
desired command.
Too many characters You attempted to enter too many numbers or
other characters in the current operation.
Press [Cancel] to delete the extra characters,
then try again. You may wish to review the oper-
ation’s appropriate instructions.
Too many locations You tried to enter department code more than
100. Your machine can store up to 100 depart-
ment codes.
Too many steps You tried to enter too many steps for a macro.
Sure to register? You can enter up to 60 steps into a macro key.
Press [YES] to tell your fax to register these
steps, or press [NO] to cancel the registering.
What you see on the LCD What it means/What to do
Unable to reduce In enlargement transmission, you cannot select
the reduction ratio.
4.3