Minolta Pi3505e/PS - Manual (Page 22)

D-1
1. DISASSEMBLY/REASSEMBLY
NOTENOTE
• Before reassembling, make sure that the amount of storage memory used is 0%.
• If the amount of memory used is not 0%, print out or delete any data in the memory.
1-1. Removing parts
The following procedures describe the removal of parts related to the network scanner, net-
work interface and printer functions.
(1)
Removing the copier covers
1. Remove the upper rear cover (3 screws).
NOTENOTE
• While removing the cover, be sure to press down
on the detecting lever for the duplexing document
feeder.
• When attaching the cover, make sure that the
detecting lever fits into the hole in the upper rear
cover.
4399U008AB
2. Disconnect the 2 cable connectors.
3. Remove the 2 cables from the cable clamp.
4. Remove the I/F CLAN circuit board cover (6
screws).
4514U002AB
Cable connectors
Cable clamp
I/F CLAN circuit
board cover