Minolta Pi3505e/PS - Manual (Page 34)

S-3
3. SOFT SWITCH
3-1. Changing soft switch settings
• In order to change the soft switch settings, display the Soft Switch Set screen, and then
specify the new setting.
• With scanner- and network-related soft switches, the screen for specifying the settings
can be displayed in two ways: from Tech. Rep. Mode or from Maintenance Mode.
(1) Displaying the setting screen from Tech. Rep. Mode
(2) Displaying the setting screen from Maintenance Mode
NOTE
• Since Tech. Rep. Mode and Maintenance Mode should not be available to the user, be
sure to turn the copier off, then on again to quit the mode after specifying the necessary
settings.
• In order to ensure that the settings have been correctly specified, check the Service Call
Report that is outputted.
1. Press the [Utility] key to display the Utility screen.
2. Touch [Meter Count].
3. Press the following keys in order to enter Tech. Rep. Mode.
Stop
→ 0 → 0 → Stop → 0 → 1
4. Touch [Soft Switch Settings].
5. In the screen that appears, specify the soft switch settings.
1. Press the [Utility] key to display the Utility screen.
2. Touch [Meter Count].
3. Press the following keys in order to enter Maintenance Mode.
Stop
→ 0 → 0 → Stop → 0 → 2
4. Touch [Maintenance Mode].
5. Touch [Soft Switch Set].
6. In the screen that appears, specify the soft switch settings.