Minolta Pi3505e/PS - Manual (Page 33)

S-2
2. CONTROLLER NETWORK SETTING
Network settings can be made either from the copier control panel or through PageScope
Light used on a network PC. Use of PageScope Light allows detailed settings that cannot
be made from the copier control panel to be made.
To use PageScope Light, it is necessary to first set the IP address for the controller by
following the procedure given below.
Assigning the IP Address
• Press the [Utility] key on the copier control panel.
• Touch [Admin. Management] and input the Administrator code.
• Touch [Admin. 2]
• Touch [Network Set]
• Touch [Basic Setting]
• Make the following settings:
IP address : IP address of the controller
Subnet mask : Subnet mask for the network to be connected
Default gateway : IP address of the default gateway
Check in advance with the network administrator on the setting values to be entered.
• Turn the Power Switch OFF and then turn it ON. (This step is necessary to validate the
data entered.)
Starting PageScope Light
• This is the tool for making settings from the Web browser of the PC connected to the net-
work. The program is mounted in the controller.
• Type the IP address of the controller in the URL field.
E.g.: http://controller_IP_address/
• Type the password in the “Admin Password” box provided at the upper left corner of the
screen, then click [Log-in]. This password should be the same as that of the copier
administrator. The default value is “00000000” (which can be changed).