MicroNet Technology SP1659P - Manual (Page 18)

The local port has to be preset its capability.
In port 1 – 24, they are supported Fast Ethernet with TP media only, so the result will show 100M/Full
or 100M/Half, 10M/Full and 10M/Half duplex.
In port 25 and port 26, if the media is 1000Mbps with TP media, it will show the combinations of
10/100M and Full/Half duplex, 1000Mbps and Full duplex only. If the media is 1000Mbps with fiber
media, it will show only 1000M/Full duplex.
Default: None, it depends on the result of the negotiation.
Rx Pause:
The way that the port adopts to process the PAUSE frame. If it shows “on”, the port will care the
PAUSE frame; otherwise, the port will ignore the PAUSE frame.
Default: None
Tx Pause:
It decides that whether the port transmits the PAUSE frame or not. If it shows “on”, the port will send
PAUSE frame; otherwise, the port will not send the PAUSE frame.
Default: None
Parameter description of Port 25 and Port26:
(Click on the hyper-link, when fiber link is connected.)
Connector Type:
Display the connector type, for instance, UTP, SC, ST, LC and so on.
Fiber Type:
Display the fiber mode, for instance, Multi-Mode, Single-Mode.
Tx Central Wavelength:
17