Meco 6623S8E641 User Manual
Page 16
16
Step 16
Bowl and Cylinder Heat Shield Assembly
Attach the Bowl and Cylinder Heat Shield to the cart with 4) 1/4-20 x .59” Bolts, 4) Fiber Washers and 4) 1/4-20 Nuts.
See detail views below for specific steps.
A.
Illustrates location of Bowl, Cylinder Heat Shield and hardware. (Note location of 1.5” long bolt)
B.
Before bolts are inserted, verify that valve nozzles are inserted into the ends of the burner tubes as shown in Detail.
C.
Illustrates location of bolts extending through Bowl Supports for attachment of Nuts.
Step 16D.
Brace Wire Attachment
D.
The short Brace Wire is attached by placing the loop
at one end over the front left bowl mounting bolt before
threading on the Nut. The lower end is attached to the left
rear leg by removing the nut holding the lower leg to the
U-Leg, placing the loop of the Brace Wire on the exposed
end of the bolt then replacing the nut.
B
C
Brace Wire
A
Fiber Washer under
each bolt head
Cylinder
Heat Shield
1/4-20 x .59” Bolt
3 pc
D
Fiber Washer
4 pc
1/4-20 Nut
4 pc
Valve
Nozzle
Valve
Burner Tube