Meco 6623S8E641 - Manual (Page 27)

27
Lighting the Grill Using the Pulse-Spark Ignitor (continued)
1. Open the Hood.
2. IMPORTANT: Make sure Control Knobs are turned “Off.” (Fig. 4)
3. Turn the LP Gas Cylinder valve open counterclockwise until it stops. (Fig. 5)
Right Main Burner
Control Knob Igniter Button
Left Main Burner
Control Knob
Fig. 4
Control Knob in
Off position
Control Knob in High
position (large flame
symbol)
Fig. 6
4. Push far left Main Burner Control Knob in on Control Panel and turn counterclockwise to the High position.
(Figs. 4 and 6)
5. Push the Igniter Button in until the Burner is lit. Listen for the spark ignition, and look to make sure the
Burner is lit. If no spark, see Troubleshooting Section on page 37.
6. From the “Off” position, light all other Burners from left to right, making sure each Burner is lit before light-
ing the next. Your grill has a Crossover Ignition System that allows the Burners to light successively off one
another. Confirm each Burner is lit before lighting another Burner.
7. If the Burner fails to light, repeat Step 4. If it still does not light, try the next Burner from left to right.
If a Burner goes out during operation, turn all Control Knobs to the “Off” position and close the LP Gas Cylinder
valve to dissipate any accumulated gas. Open Hood and wait five minutes before attempting to relight the grill.
If any or all Burners fail to light after three to four attempts following Steps 4-7, turn all Control Knobs to the
“Off” position and close the LP Gas Cylinder valve to dissipate any accumulated gas. Wait five minutes; then
repeat the lighting procedures.
NOTE: If the Burners still fail to light, refer to the Troubleshooting Section on page 38. The Burner can also
be lit manually, see
Manual Lighting of the Grill on page 28.
Fig. 5
Turn LP Gas
Cylinder valve
counterclockwise
Side Burner
Control Knob