Meco 6623S8E641 - Manual (Page 34)

34
How to Clean the Burners
1. Make sure the Control Knobs are turned “Off” and the grill is completely cooled.
2. Carefully remove the Warming Rack, Cooking Grids and Flavor Activator.
3. To remove the Main Burner, first unplug the electrode wires from the back of the Ignition box (see Step 19). Next,
remove the screws securing the burner to the bowl (under bowl - Step 15C). Last, carefully slide burner up and
back to disengage from valve nozzles and lift out of Bowl. NOTE: Do not deform Cylinder Heat Shield when
removing screws.
4. To remove the Side Burner, remove the screw securing the burner to the side table (under side table - Step 18C)
5. Use a pipe cleaner to clear insect nests from the inlet hole of Main Burner (Fig. 10) and Side Burner tube. (Fig. 11)
6. Open up the Main Burner holes (Fig. 10) and the Side Burner holes (Fig. 11) with a small nail or wire. Use a non-
metallic brush to remove food particles and corrosion from the Burner surfaces.
In order to prevent flashbacks, the Burner(s) should be removed from the grill and cleaned periodically, especially if the
grill has been stored for an extended period of time.
Burner
Valve
Control Knob
Spider webs or nest
inside Venturi Tube
Fig. 9
Fig. 10
Non-metallic
Wire Brush
Pipe Cleaner
Open up
Main Burner
holes with a
small nail or
wire.
Side Burner tube
Fig. 11
Open up Burner holes
with a small nail or wire.
Pipe Cleaner