Murphy Centurion Configurable Controller CE-05171N - Manual (Page 2)

CE-05171N page 2 of 44
WARNING!
FW MURPHY has made efforts to ensure the reliability of the
Centurion Controller and to recommend safe usage practices in
system applications. Please note that in any application, operation
and controller failures can occur. These failures may result in full
control outputs or other outputs which may cause damage to or
unsafe conditions in the equipment or process connected to the
Centurion Controller. Good engineering practices, electrical codes,
and insurance regulations require that you use independent external
protective devices to prevent potentially dangerous or unsafe condi-
tions. Assume that the Centurion Controller can fail with outputs full
on, outputs full off, or that other unexpected conditions can occur.
Please read the following information before installing the Centurion
Controller. This installation information is intended for Centurion
Controller. A visual inspection of this product before installation for
any damage during shipping is recommended.
Disconnect all power and be sure machine is inoperative before
beginning installation.
Installation is to be done only by qualified technician.
Observe all Warnings and Cautions at each section in these instruc-
tions.
Device shall be wired in accordance with Class I, Division 2 wiring
methods.
This equipment is suitable for use in Class I, Division 2, Groups B,
C, and D hazardous Areas.
WARNING–Explosion Hazard–Substitution of components may
impair suitability for Class I, Division 2.
Please contact FW MURPHY immediately if you have any questions.
Warranty
A limited warranty on materials and workmanship
is given with this FW Murphy product.
A copy of the warranty may be viewed or printed by going to
www.fwmurphy.com/support/warranty.htm
1.0 Warning and Limited Warranty
MURPHY, the Murphy logo, Centurion and C3 are registered and/or common law trademarks of Murphy Industries, Inc.
This document, including textual matter and illustrations, is copyright protected by Murphy Industries, Inc., with all rights
reserved. (c) 2004 Murphy Industries, Inc.
Windows®. Modbus® and other third party product or trade names referenced herein are the property of their respective
owners and are used for identification purposes only.