Murphy Centurion Configurable Controller CE-05171N - Manual (Page 32)

CE-05171N page 32 of 44
6 6..3 3..1 14 4 L Lu ub be e N No o F Fllo ow w S Se ett U Up p
User can view and edit Lube No Flow set up. There are two
levels to this menu as there are two possible adjustments per
No-Flow input. The user will select an input from the first menu
and press Setup/Enter. This will display the submenu for the
selected digital input if it is used for No-Flow monitoring.
Otherwise, the text label on the left side of the edit box will dis-
play “NOT IN USE”, and pressing Enter will have no effect.
At the submenu level, the user may adjust the expected tran-
sition frequency and the total cycles count (which relates to
the wear rate of the sensor).
6 6..3 3..1 15 5 L Lu ub be e N No o F Fllo ow w S Stta attu us s
The user may view information about the No-Flow inputs. If a
digital input is designated for use as a No-Flow input, it will
display how much time elapsed before the last transition, and
how much time has elapsed since that transition. If the input
is not designated as a No-Flow input, there will be zeros dis-
played. Both values have a maximum value of 999.
6 6..3 3..1 16 6 S Su up pe err U Us se err M Me en nu u
The Super User menu will only be visible if the Super User
password has been entered.
The first three selections (a – c) allow the user to temporarily
override the default behavior of the display. It may be helpful
to turn off a fault annunciation screen that prevents the view-
ing of information on operating status screens.
a a)) Com Fail Disable
b
b)) Set up T/O Disable
c
c)) Config Fail disable
Note that the reset history commands do not permanently switch
to Yes when entered, but instead toggle back to NO after sending
the command to the controller.
TM
C C C
Lube No-Flow Setup Screen
___________________________________
▼
▼
LUBE NO-FLOW SETUP
NO-FLOW INPUT # 1
DI_1 NF
NO-FLOW INPUT # 2
NO-FLOW INPUT # 3
NO-FLOW INPUT # 4
NO-FLOW INPUT # 5
▼▲ ENTER-SUBMENU
MORE MENUS
___________________________________
___________________________________
▼ ▼
TM
C C C
No-Flow # 1 Setup Screen
___________________________________
▼
▼
NO-FLOW INPUT # 1 SETUP
CYCLE TIME (SEC)
00010
TOTAL CYCLES (X100)
▼▲ ENTER-EDIT
ESC-EXIT THIS MENU
___________________________________
___________________________________
TM
C C C
Lube No-Flow Status Screen
___________________________________
▼
▼
LUBE NO-FLOW STATUS
CYCLE TIME-INPUT # 1
PREV 0 CURR 0
CYCLE TIME-INPUT # 2
CYCLE TIME-INPUT # 3
CYCLE TIME-INPUT # 4
CYCLE TIME-INPUT # 5
▼▲ CYCLE TIMER (SEC)
MORE MENUS
___________________________________
___________________________________
▼ ▼
TM
C C C
Super User Menu Screen
___________________________________
▼
▼
SUPER USER MENU
COM FAIL DISABLE
NO
SETUP T/O DISABLE
CONFIG FAIL DISABLE
RESET FAULT HISTORY
RESET EVENT HISTORY
▼▲ ENTER-EDIT
MORE MENUS
___________________________________
___________________________________
▼ ▼