Maxtor SLD240 - Manual (Page 14)

13
3.3 System Information
You can display system settings information as shown on Table 3.3 A below at any time by pressing the
Display button . In playback mode, the recorded video information is displayed. In the live or
recording mode, the Manual Recording information is displayed. However, when the DVR is displaying
a decoded image from a multiplexer, you must first switch the unit to the encoded image display (The
pictures are switching swiftly and the light of Monitor button is off) by pressing the Monitor button
. Each sequen tial press of the Display button displays a different message detailed in the
following example. By default, the unit displays time, date, and an indicating bar of hard disk capacity
status on a monitor as shown next.
Default display
(Capacity Used) (Capacity Remaining)
09- 05-2003 16:13:02
(Date) (System Time)
Press the Display button once; the DVR will display the following sample message plus the default
display. Press the Display button again; the unit will not display any OSD message. Press the
button one more time to return to the default display.
Table 3.3 A. Description of Table 3.3 A
(1+2: 59G): Total capacity of installed hard disk, 59 GB
(12.4 HR): Total 12.4 hour recording time available
( ): Timer record activated
( ): Alarm record activated
(QUALITY: BEST): Record quality setting, BEST
(NTSC): NTSC system
(20 F/S): Record speed setting, 20 fields/sec
(MUX: OFF): Only connected to a single camera
( ): Audio function activated
( ): Indicate which HDD is activated
(9K): The image file size
(HD): Hard disk compartment
(P): Y Hard disk installed; . No hard disk installed
(SIZE 20G): The capacity of the installed hard disk
(POS): Percentage of system; R: Recording; P: Playback
(IP : 192 . 168 . 1 . 90): IP Setting of the Ethernet
communication
( )
: External signal
(
X
): System Busy: Command not received
1+ 2: 59G 12.4 HR
QUALITY: BEST NTSC
20 F/S
MUX : OFF 9K
HD P SIZE POS
1 Y 20 G 39.5% P
2 Y 39 G 0.0% R
IP : 192 . 168 . 1 . 90