Maxtor SLD240 User Manual
Page 22
21
4.3 Playback Operations
This section shows you how to operate the fast, slow, and single picture playback functions, and details
how the unit is to playback a file in a different operation status. Please refer to the following paragraphs
specifying the relevant details. When playing a file, the monitor should display a flashing PLAY message
and the PLAY button
will light up indicating that the DVR is in the playback status.
Operation Status
A. From REC Mode to Playback Mode
(In live mode, directly press the PLAY button
to play a latest recorded video)
In recording mode, press the stop button. Press play to play back the video just recorded.
B. Search to Play Back a Particular Recorded Video
For this type of playback, refer to Section 4.4.
C. Play Back from the Oldest Data
Press and hold the stop button for 3 seconds. The “Stop” indicator will appear on the top right side of the
screen. To play the oldest video, press PLAY.
4.3.1 Fast Forward/Reverse
There are 7 speeds available for playback: 1x, 2x, 4x, 8x, 16x, 30x and 100x
While playing back recorded video at recorded speed:
Forward: Turn the Shuttle dial
clockwise to view the recorded video in the forward direction at a
speed faster than the recorded speed. Each subsequent turn of the shuttle clockwise increases
the forward rate, as 2x, 4x, 8x, 16x, 30x and 100x.
Reverse: Turn the Shuttle dial
counterclockwise to view the recor ded video in the reverse direction
at a speed faster than the recorded speed. Each subsequent turn of the shuttle to the
counterclockwise increases the reverse rate, as -1x, -2x, -4x, -8x, -16x, -30x and -100x.
Normal:
Release the Shuttle dial
to return to the normal speed of playback.
* You can also operate by using “<” button
and “>” button
.
NOTE: When playing a recorded video through a multiplexer at 60 F/S or 30F/S, the playback
speed is half of the recorded speed.
NOTE: The playback speed will be displayed on the screen. However, when playing a recorded
video from a multiplexer, the playback speed will only display in encoding (multiplexing)
mode. Press the Monitor button
to switch between decoding and encoding modes.