Maxtor SLD240 - Manual (Page 54)

53
9.2 Configure Your DVR Network Settings
Upon network hardware connection, you need to activate the network function and configure the
proper network settings of the DVR.
9.2.1 Enable DVR Network Function
?? Press the Setup button to enter the OSD MAIN MENU. Please use the“<” “>” buttons
and to highlight COMMUNICATION; then press the Enter button to enter the COMM
SETTING page.
?? Use the “ ^ ” “v” buttons and to highlight NET ENABLE; select ON. Then press the
Enter button to proceed.
9.2.2 Enable DHCP Function
?? Use the “ ^ ” and “v” buttons , and , to highlight NET DHCP; select ON. Then
press the Enter button to proceed.
NOTE: This function ca n only work if the LAN which the unit is connected to has a DHCP
server. If the DHCP server is working, the DVR will obtain an IP address automatically
from the DHCP server. In that case please skip the S ection 9.2.3 (Set IP address) and
follow Section 9.3. (TCP/IP Communication Software).
MAIN MENU
RECORD
ALARM
CLOCK / TIMER
COMMUNICATION
DISK
SYSTEM
GOTO COMM PAGE
COMM SETTING
COMM ID
: 01
RS232 : ON
RS485 : ON
NET ENABLE : ON
NET DHCP : OFF
NET IP : SET
FTP SETTING
MAIN PAGE
ETHERNET ENABLE
MAIN MENU
RECORD
ALARM
CLOCK / TIMER
COMMUNICATION
DISK
SYSTEM
GOTO COMM PAGE
COMM SETTING
COMM ID
: 01
RS232 : ON
RS485 : ON
NET ENABLE : ON
NET DHCP : ON
NET IP : SET
FTP SETTING
MAIN PAGE
SET ETHERNET DHCP