Maxtor SLD240 - Manual (Page 35)

34
PRE- ALARM:
This option allows for images prior to alarm trigger to be recorded on the hard disk drive. When an alarm
is triggered, the device will record the images prior to the alarm for 5 seconds. ( 20 fields/sec )
ON: Enables this function.
OFF: Disables this function.
NOTE: If the device is already under recording mode before alarm occurs, the pre-alarm recording
will not take effect.
MOTION SETTING:
The motion detection function is convenient for people without an alarm trigger input, but also can used
with an alarm trigger input at the same time. If this function is enabled, the object movement would trigger
the alarm recording just like the outside trigger signal, such as a door switch. Before using the motion
detection function, please turn the ENABLE option as ON, and set the SENSITIVITY (1 ~ 5) to a suitable
value.
NOTE: The MOTION ENABLE option can not be activated when the MULTIPLEXER option ( in
REC SETTING page ) is set to ON. The motion detection feature is for single camera use
only.
MOTION ENABLE:
This option enables / disables the motion detection.
ON: Enables the motion detection.
OFF: Disables the s motion detection.
SENSITIVITY:
This option allows users to set the motion sensitivity.
1 is the most sensitive setting. 5 is the least sensitive setting.
REGION
This option allows users to set the motion region.
MOTION SETTING
MOTION ENABLE : ON
SENSITIVITY : 3
REGION
: SET
MAIN PAGE
ENABLE MOTION DETECTION
SET MOTION REGION
( 30 , 30 ) – ( 90 , 70 )