Moyer Diebel 301HT M2 - Manual (Page 15)

7
Initial Start Up
The following is a summary of your model 301HT dishwasher operating cycle:
1. The door must be closed to begin the cycle.
2. Press the
POWER button to fill the wash tank.
3. The booster heater comes on when the correct water level has been reached.
4. Press and hold the
START button to start the cycle. NOTE : After pushing the start button
the first cycle of each day could take at least 15-20 minutes if the machine was not allowed
to warm up first.
5. The pump runs during the wash cycle for approximately 120 seconds. The wash cycle
duration is extended if the booster water temperature does not reach 180°F/82°C.
6. After a 5 second pause, the fill valve opens and the rinse cycle starts.
7. The machine rinses for 15 seconds. The cycle light turns off indicating that the cycle is
complete. DO NOT open the door until the cycle light turns off.
8. Open the door and remove the rack of clean ware.
Installation