MRV Communications EM316EDFA-BR User Manual
Page 15
Advertising
Fiber Driver
®
EM316EDFA User Guide
P/N 1294008-001 Rev D2
6
Step 2
Install the module into a Fiber Driver chassis by aligning the edge of the card with the rail
of the chassis. Tighten the thumbscrew by hand.
Figure 5 -- Module installation (not all chassis are shown)
Handle modules by the edges to avoid damaging any components. Follow all ESD precautions
listed at the front of this manual. Use your thumb to push the module securely into the chassis slot.
Do not use excessive force, but make sure the module connector is fully inserted in the chassis.
Secure the module by hand using the thumbscrew.
Figure 6 -- Fiber Driver module installed in a powered chassis
Advertising
This manual is related to the following products: