5 configuring system parameters – MRV Communications EM316EDFA-BR User Manual

Page 26

Advertising
background image

Fiber Driver

®

EM316EDFA User Guide


P/N 1294008-001 Rev D2

17


5.2.3.5 Configuring System Parameters

Enter "configuration" mode, as shown below, to configure the system parameters

fiberdriver# configure terminal



Note that each command is completed with the <CR> or <Enter> key, which is not printable.


Once the mode is changed, the prompt also changes. Change the SUPER user password
using the "username" command.

fiberdriver(config)# username admin password <new password>


Set the IP configuration using the "ip" command group. Set IP address and IP mask
information using the following command.

fiberdriver(config)# ip interface 169.254.88.200/16


The IP address (169.254.88.200) and the netmask (16) are examples only. Use the IP
address and netmask appropriate for the EM316LNXNM-OT on your network. Classless
Inter-Domain Routing (CIDR) notation is used to specify the address (169.254.88.200) and
mask (16) corresponding to 255.255.0.0.


Set specific gateway information using the following command:

fiberdriver(config)# ip default gateway 169.254.88.1


The IP information configured does not load until restarting the system or using the
command:

ip interface update


Use the following command to save the configuration into permanent (non-volatile) storage:

fiberdriver(config)# write file
fiberdriver(config)# exit


The system does not automatically save configurations to permanent storage. Use the
write file

command to save a configuration before restarting the system. Now the IP

configuration is complete. The default SNMP community names are "public" for read and
"private" for write.

Use the description command to change names of the chassis, slot, and port. Use the show
command to verify the change. Chassis names are limited to nine characters.

Advertising
This manual is related to the following products: