6 port context commands and examples – MRV Communications EM316EDFA-BR User Manual
Page 35
Fiber Driver
®
EM316EDFA User Guide
P/N 1294008-001 Rev D2
26
5.2.6 Port Context Commands and Examples
The table below lists commands that relate specifically to EDFA modules in the port-level
command context of the EM316LNXNM-OT command line interface (CLI). Some sample
commands are illustrated in this section following the command table. A specific command list
for each context is displayed by typing the “?” command at any prompt.
Command
Description
default
Restore parameter(s) to defaults
description
Set port name
echo
Display text for scripting
end
End current mode and go down to enable node
exit
Exit current mode and go down to previous mode
list
Print command list
logout
Logout of the system
next
Configure next element
no
Negate a command
pager
Pause scrolling when screen is full
port
Configure a port
previous
Configure previous element
quit
Exit current mode and go down to previous mode
rm-chassis
Set remote chassis connectivity information
rm-port
Set remote port connectivity information
rm-slot
Set remote slot connectivity information
show
Show basic info
shutdown
Disable the port
sleep
Pause CLI for scripting
speed
Adjust port speed
up
Configure parent element
who
Find out who is connected to the system
whoami
Who am I?
write
Write running configuration to memory or terminal
Figure 9 – EM316LNXNM-OT port context commands for EDFA modules