5 slot context commands and examples – MRV Communications EM316EDFA-BR User Manual
Page 29
Fiber Driver
®
EM316EDFA User Guide
P/N 1294008-001 Rev D2
20
5.2.5 Slot Context Commands and Examples
The table below lists commands that relate specifically to the EDFA modules in the slot-level
command context of the EM316LNXNM-OT command line interface (CLI). Some sample
commands are illustrated in this section following the command table.
Command
Description
clear-type
Clear Type, if locking types
default
Restore parameter(s) to defaults
description
Set slot name
echo
Display text for scripting
end
End current mode and go down to enable node
exit
Exit current mode and go down to previous mode
list
Print command list
logout
Logout of the system
next
Configure next element
no
Negate a command
pager
Pause scrolling when screen is full
port
Configure a port
previous
Configure previous element
quit
Exit current mode and go down to previous mode
reset
Reset systems on this slot
show
Show basic info
sleep
Pause CLI for scripting
slot
Configure a slot
up
Configure parent element
who
Find out who is connected to the system
whoami
Who am I?
write
Write running configuration to memory or terminal
Figure 8 – EM316LNXNM-OT slot context commands for EDFA modules
Command examples in this section are applied in the slot-level context. The box below shows
the command to navigate to the slot context from the login context.
fiberdriver# configure terminal
fiberdriver(config)#
fiberdriver(config)# slot 1.1
fiberdriver(slot/1.1)#