Miller Electric XMS 44 - Manual (Page 19)

OM-223 839 Page 15
4-9. Preparing Unit For MIG Welding
To select MIG welding process, pro-
ceed as follows:
Follow safety precautions according to
Section 1.
Prepare unit according to Section 3.
1
Using a cable with a proper
adapter, connect gun to the MIG
gun connector.
Connect work clamp cable to the
WORK connector on the power source.
2
If using a water-cooled gun,
connect input coolant hose to blue
quick connect fitting
3 Connect return coolant hose to
red quick connect fitting.
Check coolant level after attaching
torch coolant hoses and running cooler.
Be sure coolant appears in upper half of
indicator. Add coolant if necessary (see
Power Source manual).
4
If a remote control is desired,
connect it to the Remote Control
receptacle
Turn unit On.
Allow time for unit to complete its start
up cycle.
Set MIG welding process on the Power
Source and check L1, L2, L3 and L4 on
the Wire Feeder.
Purge air from the gas hose using P3
pushbutton (see Section 4-8).
4
2
3
1