Multi-Tech Systems MTS2SA-T - Manual (Page 38)

Chapter 4 – Command Line Interface (CLI)
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 38
Serial Commands – Setup
Command Syntax set serial [s0/s1] modem init-string <init-num> <init-str>
Description Configures the modem initial strings.
Init-num can range from 1-5.
Triggers for a reboot upon save.
Example: Set serial s0 modem init-string 1 ATZ
Set serial s0 modem init-string 1 "ATZ AT&F"
Important Note:
Use double quotes if more than one word is used in the <init-str>. Refer to
example 2 above. This holds true for all the following commands that need
a string as a parameter.
Default Value Init-string 1 is set to 'ATZ'
Init-string 2 is set to ' '
Init-string 3 is set to ' '
Init-string 4 is set to ' '
Init-string 5 is set to ' '
Success OK
Error 1. Too few arguments
"Usage: set serial s0/s1 modem init-string <init-num> <init-str>
Type 'set serial s0/s1 modem init-string ?' for more information"
Invalid init-num
"ERROR: init-num range supported : [1-5]"
Command Syntax set serial [s0/s1] modem ok-string <ok-str>
Description Sets the modem OK string.
Triggers for a reboot upon save.
Default Value OK
Success OK
Error 1. Too few arguments
"Usage: set serial s0/s1 modem ok-string <ok-str>
Type 'set serial s0/s1 modem ok-string ?' for more information"
Command Syntax set serial [s0/s1] modem ring-string <ring-str>
Description Sets the modem ring string. Triggers for a reboot upon save.
Default Value RING
Success OK
Error 1. Too few arguments
"Usage: set serial s0/s1 modem ring-string <ring-str>
Type 'set serial s0/s1 modem ring-string ?' for more information"
Command Syntax set serial [s0/s1] parity <even/odd/none>
Description Sets parity to even/odd/none.
Default Value None
Success OK
Error 1. Too few arguments
“Usage: set serial s0/s1 parity <even/odd/none>
Type ‘set serial s0/s1 parity ?’ for more information”
2. Invalid parity setting
“error: parity supported: [even/odd/none]
Type ‘set serial s0/s1 parity ?’ for more information”