Multi-Tech Systems MTS2SA-T - Manual (Page 47)

Chapter 4 – Command Line Interface (CLI)
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 47
HTTP Server Commands – Setup
HTTP Server Commands
The commands in this section are listed in the order in which they might be used.
Command Syntax set ip http-page <default/serial>
Description This parameter is used by the http server to host the default HTML index or
host-defined http-serial-S0 HTML page.
Default Value Default
Success OK
Error 1. Too few arguments
“Usage: set ip http-page <default/serial>
Type set ip http-page ?”
2. Invalid string
Type "set ip http-page ?”
Command Syntax set ip http <enable/disable>
Description This enables the http server on the MultiConnect IP to listen on Port 80.
Default Value Disable
Success OK
Error 1. Too few arguments
“Usage: set "ip http <enable/disable>
Type 'set ip http ?' for more information"
2. Invalid string
"ERROR: Invalid string
Type 'set ip http ?' for more information"
Command Syntax set ip http-port <port>
Description Sets the HTTP server to listen on the specified port.
Default Value 80
Success OK
Error 1. Too few arguments
“Usage: set ip http-port <port>
Type set 'ip http-port ?' for more information”
2. Invalid port number
"ERROR: Invalid port number
Type set 'ip http-port ?' for more information”
Command Syntax set device-parameter P<n> <value>
where n = 0 to 99.
Description Sets the value of the parameter from the host/serial device.
Default Value Value in the default parameter list file uploaded through TFTP.
Success OK
Error 1. Too few arguments
“Usage: set device P<n> <value>
Type 'set device P<n> ?' for more information”
2. Invalid string
"ERROR: Invalid string
Type 'set device P<n> ?' for more information”