Multi-Tech Systems MTS2SA-T - Manual (Page 66)

Chapter 7 – Telnet Dialout
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 66
Optional Configuration Commands
(Return to Scenario 1 - Setup Manual Dialout Notes: )
(Return to Scenario 2 - Auto Dialout Prerequisites )
(Return to Scenario 3 - Auto Dial-out in RAW-Mode Notes: )
The following commands can be used for optional configurations:
•
Enable/Disable the Authentication for Dial-out session
# set login auto-dialout-login <enable/disable>
•
Enable/Disable the Switching-between-Dialout & Command Prompt feature
# set ip telnet escape-monitor <enable/disable>
•
Set the Escape-Monitor-String to switch between Dialout and Command Prompt sessions.
# set ip telnet escape-string "+++inet"
•
Enable/Disable the RAW mode globally for all Dial-out sessions.
# set ip telnet raw-mode <enable/disable>
•
Enable/Disable the RAW mode for the serial port S0.
# set serial s0 raw-dialout <enable/disable>
•
Set the Baud rate for the serial port S0 to be taken for a Dialout session.
# set serial s0 baud-rate <Baud-rate>
•
Set the Flow control for the serial port S0 to be taken for a Dialout session.
# set serial s0 flow-control <rts-cts/none>
•
Set the Parity for the serial port S0 to be taken for a Dialout session.
# set serial s0 parity <even/odd/none>
•
Set the Data bits for the serial port S0 to be taken for a Dialout session.
# set serial s0 data-bits <7/8>
•
Set the Stop bits for the serial port S0 to be taken for a Dialout session.
# set serial s0 stop-bits <1/1.5/2>
•
Set the Flow control for the serial port S1 to be taken for a PPP session
# set serial s1 flow-control <rts-cts/none>
•
Set the Parity for the serial port S1 to be taken for a PPP session
# set serial s1 parity <even/odd/none>
•
Set the Data bits for the serial port S1 to be taken for a PPP session
# set serial s1 data-bits <7/8>
•
Set the Stop bits for the serial port S1 to be taken for a PPP session
# set serial s1 stop-bits <1/1.5/2>