Mercedes-Benz 2005 E 320 - Manual (Page 282)

281
Controls in detail
Useful features
Step 9:
̈ Press “training” button on the garage
door opener motor head unit.
The “training light” is activated.
You have 30 seconds to initiate the follow-
ing step.
Step 10:
̈ Firmly press, hold for two seconds and
release the programmed integrated
signal transmitter button (
1, 2
or 3).
Step 11:
̈ Press, hold for two seconds and re-
lease same button a second time to
complete the training process.
Some garage door openers (or other rolling
code equipped devices) may require you to
perform this procedure a third time to
complete the training.
Step 12:
̈ Confirm the garage door operation by
pressing the programmed integrated
signal transmitter button (
1, 2
or 3).
Step 13:
̈ To program the remaining two buttons,
repeat the steps above starting with
step 3.
Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the inte-
grated signal transmitter to pick up the sig-
nal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner.
If you live in Canada or if you are having dif-
ficulties programming a gate operator (re-
gardless of where you live) by using the
programming procedures, replace step 4
with the following:
Step 4:
̈ Continue to press and hold the inte-
grated signal transmitter button (
1,
2 or 3) while you press and re-press
(“cycle”) your hand-held remote con-
trol transmitter
6 every two seconds
until the frequency signal has been
learned. Upon successful training, the
indicator lamp
4 will flash slowly and
then rapidly after several seconds.
̈ Proceed with programming step 5 and
step 6 to complete.