Motorola VC5090 - Manual (Page 184)

7 - 18 VC5090 Vehicle Computer Product Reference Guide
TCM Error Messages
TCM validates the cells in the partition table when the Execute button is clicked. Cells highlighted in red contain an
error. Partition loading is disabled until all errors are corrected.
Table 7-3 TCM Error Messages
Error Description/Solution
Failed to build images:
flash file system DLL not
loaded! TCM could not load the DLL required to build images for the targeting flash file system.
Reinstall TCM or recover the DLL.
Failure finding directory
xxx Building process failed because directory xxx was not found.
Failure creating volume Building process failed because a certain disk volume could not be created.
Failure adding system
file to image Build process failed because TCM failed to add a certain system file to the disk image.
INVALID PATH The path for the image file to build is not valid.
Nothing Selected To
Build In the Config Build window, no item is selected to build.
Illegal ESS ID In the Build ESSID Partition window, no ESS ID was entered or the ESS ID entered was
illegal.
Disk Full TCM failed to create Hex image file at the selected path. Check available disk space.
Target Disk Full Build process failed because TCM failed to add file to the image of a disk volume.
Remove some files or increase the disk size.
Hex file is READ ONLY The Hex image file to be created exists and is read-only. Delete the existing file or
change its attribute.
Error opening the file
xxx with write access TCM could not open file xxx with write access. Check if file is in use.
Failure creating binary
file TCM failed to open/create an intermediate binary file.
Hex File To load is
missing or invalid In Load Terminal window, the file selected to load has invalid status.
Could not locate vehicle
computer name in
TCM.ini file While loading the Script Properties window, TCM could not find the TCM.ini section
corresponding to the vehicle computer type specified by the current opening script.
Either TCM.ini or the script file is invalid.
Incorrect disk sizes in
TCM.ini file The total disk size specified in the script does not match the total disk size defined in the
corresponding TCM.ini section. Check if the script is corrupt or the TCM.ini has changed
after the script was created.
INVALID DIRECTORY In Script Properties window, the selected System File Path is not a valid directory.
One of the disk sizes is
one sector in size In Script Properties window, one of the disks is too small (one sector in size). This may
cause problem while building images, especially when cushion is enabled. Increase the
disk size.