Motorola VC5090 - Manual (Page 67)

Installation 2 - 39
Figure 2-56 Switch Installation Example (Switch Normally Open)
Cable Installation
One end of the cable connects to a customer provided switch and the other end connects to the COM1 or COM2
port on the vehicle computer.
To install the Vehicle In-Motion Detector cable:
1. Follow these recommendations when installing the cable:
• Establish a neat route for the cable, staying clear of moving parts or hot surfaces.
• Place the cable in a rigid sleeve or conduit to protect the cable.
• When the cabling must go through a panel, use a suitable gland.
• When fixing the conduit or cable on the outside of a vehicle, use P-Clips. Either drill and tap the hole or use a
nut and bolt to secure the clip.
• Ensure the cable does not have tight bends. The minimum recommended radius is 2.5".
• Solder all wire connections.
2. Wire the cable and switch as shown in Figure 2-57 .
Switch (Open)
Accelerator
Pedal
Switch (Closed)
Accelerator
Pedal
Mounting
Hardware Mounting
Hardware
Cable Cable
Vehicle Stationary Vehicle In-Motion
Note: Diagram is for concept only. Actual switch, pedal, mounting hardware and installation vary depending upon the
type of vehicle and hardware used.
Only available on vehicle computers with OEM Version 05.26.0000 or higher.