Metrologic Instruments Genesis MS7580 - Manual (Page 10)

6
I
NTRODUCTION
Labels
Each MS7580 has a label located near the top of the output window. This label
provides the unit’s model number, date of manufacture, serial number, CE and
caution information. Additional information has been molded into the underside
of the unit's case. The following figure gives an example of the label and the
molded text with their locations identified.
Figure 4. Label and Molded Text Samples
Caution
To maintain compliance with applicable standards, all circuits connected to the scanner must
meet the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC 60950-1.
To maintain compliance with standard CSA C22.2 No. 60950-1/UL 60950-1 and norm
EN/IEC 60950-1, the power source should meet applicable performance requirements for a
limited power source.
Maintenance
Smudges and dirt on the unit's window can interfere with the unit's performance.
If the window requires cleaning, use only a mild glass cleaner containing no
ammonia. When cleaning the window, spray the cleaner onto a lint free, non-
abrasive cleaning cloth then gently wipe the window clean.
If the unit's case requires cleaning, use a mild cleaning agent that does not
contain strong oxidizing chemicals. Strong cleaning agents may discolor or
damage the unit's exterior.