Metrologic Instruments Genesis MS7580 - Manual (Page 14)

10
I
NSTALLATION
USB
1. Turn off the host device.
2. Plug the male 10-pin RJ45 end
of the USB cable into the 10-pin
socket on the MS7580. There will
be an audible click when the
connector lock engages.
3. Plug the USB end of the cable into
the host’s USB port.
Steps 4 and 5 are for VLink cables with
a built in power jack and 12V external
power supply. Skip to step 6 for USB
direct connect cables
‹ receiving 12V
power from the host .
4. Plug the power supply into the
power jack on the VLink cable.
Check the AC input
requirements of the power
supply to verify the voltage
matches the AC outlet.
The outlet must be located
near the equipment and be
easily accessible.
5. Connect AC power to the transformer.
6. Turn on the host device.
7. The MS7580 will start to initialize. The white and blue LED will alternately
fade on and off for approximately three seconds. When the scanner has
finished initializing, the unit will flash the white LED three times while
simultaneously beeping three times. The low intensity blue LED will remain
turned on.
‹ The MS7580 requires 12V power from the host for pass-through capabilities to function.
See page 3 for a complete list of USB cable options.
See caution on page 6.
Figure 8.